plastic processing injection moulding maker
1:0.007g 2:0.01g 3: 0.07g 4: 0.11g 5: 0.02g
2 plast mold
Those five products in one mold. Just one product need two lift stuctures. so note that the lift moving angle is normally 3-8 °, less than 15 °.and the ejection stroke need to additional 0.5-1mm.also the width of the lift is relatively small, and an additional frame is added to the ejector plate to shorten the height of the lift to ensure strength. we make three shut runner inserts for the situation what we just want to production one of them.
This mold's cooling system is running very fast because of two short distance water line.
you can see the different part size made the different runner size. its for balance injeciton.
Each product draft angle analysis for avoid sticking cavity inssures.
See below picture each product wall thickness analys is good for finding out the
potential sink problems.
ABIS MOLD was founded in 1996. We are focused on plastic injecion mold and good at it.
Please send the RFQ for comparing. This is Nancy, I was a plastic injection mold designer
start 9 years ago. hope to grow better with you. Thanks for watch.