Working principle the mould temperature machine consists of water tank

- Jun 26, 2018-

Working principle the mould temperature machine consists of water tank, heating and cooling system, power transmission system, liquid level control system, temperature sensor, injection port and other devices.Normally, the pumps in the power transmission system allow the heat fluid to reach the mold from the tank with the built-in heater and cooler, and then from the mold back to the tank.The temperature sensor measures the temperature of the thermal fluid and transmits the data to the controller in the control section.The controller adjusts the temperature of the hot fluid, thus indirectly adjusting the temperature of the mould.If in production mold temperature machine, mould temperature more than set value of the controller, the controller will open the solenoid valve connected to feed line, until the temperature of the heat transfer fluid, namely the temperature of the mold back to the set value.If the mold temperature is below the set value, the controller will turn on the heater.


Previous:What plastic products can be molded by injection molding machine Next:The precondition temperature control system